First Time Use.
Your new electronic cigarette consists of 3 main parts, first being your battery. This will be your energy source for your electronic cigarette. Make sure you charge each battery for a full 8 hours before use to maximize the life of your battery. To do this, you must first place the battery in the charger and then rotate clockwise until tight. Then you have the option to connect your charger to the usb port of your computer, or into the wall plug adapter. After the full 8 hour charge, you can now connect your battery to the next part, the atomizer.
Your atomizer sounds more complicated than it actually is. The atomizer is essentially a heater to create vapor for you e cig. Connecting your battery to the atomizer will create a proper circuit to send power to the atomizer. Once you connect your battery with the atomizer, you are at your final step.
The final part to create your electronic cigarette is the cartridge. The cartridge is just a container of liquid that the atomizer will turn into vapor once connected. Take the end of the cartridge covered with a foil seal and place it inside the atomizer until the edges meet. You will feel a little pressure as you are breaking the seal on the foil. Once this is completed, you have successfully assembled your new electronic cigarette.
Your cartridges will come pre filled with e liquid, so make sure you do not try to load any additional liquid. This will cause the cartridge to be overfilled and overflow. If you are using your atomizer for the first time or you have used the unit until the cartridge is dry, it may be a good idea to place a drop or 2 of your e liquid into the opening of the atomizer. When you are not receiving enough flavor from your cigarette, you simply need to take it off the atomizer and refill the cartridge with about 3 to 5 drops of your e liquid. Be careful not to overfill your cartridge, and wipe any excess liquid off the outside. You may now place the cartridge back on the atomizer and continue normal use.
Here is a link for our Users Manual to assist you further if you are more of a visual learner.
PCC Charger Setup
Your PCC charger will provide your batteries a charge even when not near an outlet or usb port. Here are some very simple directions on the correct use of your PCC charger.
Step 1 - Place e cig battery in right most opening in the case.
Step 2 - Rotate e cig battery clockwise until snug fit is achieved.
Step 3 - Press and hold button on the front of the case until the battery starts blinking.
At the end of the blinking sequence, the light on the front of the case will turn green if charged, or red if a charge is needed
Here are some definitions on the three separate parts that make an electronic cigarette
Inside your battery is a small circuit board at the tip of the unit containing an LED light , lithium-ion battery, small microchip, and a small mechanical switch that is turned on when you take a drag on the mouthpiece of your electronic cigarette. The LED indicates whether the E CIGS battery is in use (solid light) or if the battery needs to be recharged (blinking light). The efox e cigarette (510) work’s better and more efficient than any other e cigarette in its size class!
The atomizer is a lot simpler than it sounds. Simply put, it’s a small heater that heats the oil in the electronic cigarette cartridge and makes the vapor. The 510 electronic cigarette is well known for having the greatest amount of vapor.
The cartridge is both a mouth piece, and the container that holds your e liquid. All efox cartridges are completely refillable with our e liquid. Having refillable cartridges helps out our customers by saving money, as well as keeping our planet around a little longer by reducing the waste of disposable cartridges.
We hope this information has helped you. If you have further questions, you can also see more at our FAQ's page our contact our Tech Support.
Happy Vaping!